A very simple class B power amplifier electronic project can be designed using TDA8560 audio IC. The TDA8560 amplifier has an internally fixed voltage gain for excellent channel balance . This audio amplifier electronic project will provide a dual 40 watt output power . This audio amplifier IC is specially designed for car audio applications.
A diagnostic facility senses distortion, load short-circuit and temperature . At onset of distortion or temperature >150 °C, the diagnostic output signal can be used to reduce the input drive via a sound processor or DC volume control. For load short-circuit or output short-circuit to ground or supply, the outputs are switched-off until the short-circuit is removed.
This amplifier will produce 40 watt per channel output power on a 2 ohms load and 25 watt per channel output power on a 4 ohms load .
This audio amplifier electronic project must be powered from a 14.4 volts DC power supply .
Subscribe
Comments
Mode select is used to
Mode select is used to Standby Mute switching, take a look in the datasheet
is a mistake 470uF capacitors are 470nF
apart from 470uf, which can
apart from 470uf, which can be used instead of the two.
i have made this circuit but
i have made this circuit but am defeated how i can connect/ where to connect mode select and DIAG OUT. Please help i don"t understand these two terms(mode select and DIAG OUT
Post new comment